- Fits:
- YAMAHA V-MAX1200 85-08
The clutch was a normal clutch that had been used for many years, but after 80,000km, it recently started slipping, so we decided to replace it with an Advantage FCC. Since it was a good opportunity, ...Read More - Fits:
- HONDA CB1000 SUPER FOUR (Big One) T2
- HONDA
- HONDA CBR1000F 87-96
OEMClutch started to slip, so I replaced it at the time of ClutchOH.Spring length is a little long? The OEM was not so bad?The Clutch is now a little heavier, but no longer slips, and the feel when co...Read More - Fits:
- YAMAHA V-MAX1200 85-08
It was OEM and a little slippery.When I switched to this one, they are tightly connected and do not slip at all.As one would expect from the FCC.Durability was not bad, and it did not seem to diminish...Read More - Fits:
- KAWASAKI 250TR 02-11
- KAWASAKI BALIUS 91-96
- KAWASAKI BALIUS-II 97-07
- KAWASAKI ELIMINATOR250V 98-07
- KAWASAKI ESTORELLA 02-11
- ...and more.
I did the Bore up and used the OEM Clutch, and sure enough, it slipped & hellip; I could use it, but the Torque increased with the Bore up, and the Embrake became harder, so I changed to this one with...Read More - Fits:
- YAMAHA YZF1000 THUNDER ACE ThunderAce
- YAMAHA FZR1000 4PM2
- YAMAHA FZR1000 3LE7
- YAMAHA FZR1000 3GM
* Measure the weight of the spring includedIt is 30Gram lighter than NORMAL* Length of SpringIt's a bit longer than NORMAL, but the hardness might not change.Is it corresponding to 3GM5 '91 because it...Read More - Fits:
- YAMAHA TW200E 98-01
- YAMAHA TW225E 02-07
- YAMAHA TW200 87-97
I purchased this product to reduce embrittlement and friction loss.It's expensive, but it's really good.good pointEmbracing is calm. So you can concentrate only on cornering on the way down.● It also ...Read More - Fits:
- HONDA CB750 RC42
After 20 years from new I finally had to change the clutch in my Honda CB750 RC42. Especially now that I run a Keihin CR31 carb and CBX750 RC17 camshafts it will need a good clutch with this increased...Read More - Fits:
- SUZUKI GSX750 KATANA
- SUZUKI GSX750 KATANA 2
- SUZUKI GSX750 KATANA D SPECIAL+1Type
- SUZUKI GSX750 KATANA D
- SUZUKI GSX750 KATANA S SPECIAL+1Type
- ...and more.
The Clutch started to slip, so I installed it as a repair.Slippage was cured, but Clutch's weight was improved.My KATANA, coupled with YRP's Easy Clutch, is a finger Quantity:2pc will cut Clutch.Read More - Fits:
- SUZUKI GSX750 KATANA
- SUZUKI GSX750 KATANA 2
- SUZUKI GSX750 KATANA D SPECIAL+1Type
- SUZUKI GSX750 KATANA D
- SUZUKI GSX750 KATANA S SPECIAL+1Type
- ...and more.
[First things first].For some reason, the 750S1/S2 Clutch is notorious for being heavier to pull than the 1100S.Even on a day touring, my left hand was a wreck on the way home, so it was serious enoug...Read More - Fits:
- SUZUKI GSX-S1000SR New KATANA
- SUZUKI GSX-S1000 16-21
If you replace it as it is, the Clutch Wire interferes with the Tube. I returned it to OEM because I felt that it would break if I didn't do something about it.It's a shame because I did feel like I w...Read More - Fits:
- KAWASAKI 750SS MACHIV (H2) (H-2)
I've been suffering from the disease of not being able to blow the Engine for nearly two years.After two laps of electrical and mechanical review, we finally made it to the finish line.And it's in the...Read More - Fits:
- YAMAHA Bronco. 97
- YAMAHA Selo 225S 92-95
- YAMAHA Cerro 225W 93-96
- YAMAHA Serow 225WE 97-04
- YAMAHA CELLOW 225 86
- ...and more.
I installed it on the SEROW225 whose Clutch was getting low.Since I was recommended to exchange the combination with the Retainer of Kitamura Workshop, Quantity:Purchased in a set and built in.I don't...Read More - Fits:
- YAMAHA WR250R 07-16
- YAMAHA WR250X 07-16
I installed it on Racer's WR250X, the OEM Clutch slipped so I replaced it with this one. Intake/exhaust, ECU was rewritten and there was power, but it may be overspecifications for me because I don't ...Read More - Fits:
- KAWASAKI VOYAGER1200
- KAWASAKI ZEPHYR1100 RS
- KAWASAKI ZEPHYR1100
- KAWASAKI ELIMINATOR 900 A2
- KAWASAKI ELIMINATOR 900 A1
- ...and more.
It was a bit of a hassle to clean off the stuck-on Gasket, but if you polish it off with Oil stone, it's not that large a task, so it was right to replace it by myself.Since I soaked the Clutch Plates...Read More - Fits:
- HONDA CB1300 SF 03-15
- HONDA CB1300SUPER BOLDOR 05-15
If my prediction of CB1300 is correct, it has 60,000km and no Clutch circumference for 12 years Since it was a replacement, I also changed the ride qualityIt's relatively easy to replace the CBs becau...Read More - Fits:
- SUZUKI GSX750 KATANA
- SUZUKI GSX750 KATANA 2
- SUZUKI GSX750 KATANA D SPECIAL+1Type
- SUZUKI GSX750 KATANA D
- SUZUKI GSX750 KATANA S SPECIAL+1Type
- ...and more.
It was installed in the shop together with the LightClutch holder two years ago in the springIt's taken me a while since you put together WossnerPiston about two years before that I got used to it, so...Read More - Fits:
- KAWASAKI KX250F 04-15
- SUZUKI RM-Z250 04-13
- YAMAHA WR250R 01-08
- YAMAHA YZ250F 01-13
The phrase "Silent chain" is used, so it's normal to say it's quietI don't know about the word RACINGThe price is about 8 times more expensive than OEM, but the structure and material are the sameThe ...Read More - Fits:
- KAWASAKI KZ1000
- KAWASAKI KZ1000MK-II Conversion kit for Z series clutch Z1000J (including FCC Spl+1 clutch kit/Spl pressure plate/Spl hub)
- KAWASAKI Z1
- KAWASAKI Z1-R
- KAWASAKI Z1R-2
- ...and more.
I bought it from webike a long time ago at the same time I purchased the Z1It was asleep because we couldn't install it without breaking the engine due to our lack of knowledge! (Since I ride gs1000, ...Read More - Fits:
- KAWASAKI 250TR 02-11
- KAWASAKI BALIUS 91-96
- KAWASAKI BALIUS-II 97-07
- KAWASAKI ELIMINATOR250V 98-07
- KAWASAKI ESTORELLA 02-11
- ...and more.
Cosmetically, I think it's a bit expensiveBut, well, the Other Brand Product from Reinforced Clutch in Est I don't have any other options, so I have to choose this oneNORMAL is friction plate (t2.7) S...Read More - Fits:
- KAWASAKI ZX-12R 00
I was using Barnett Reinforced Clutch, but it started to slide at the start, so I bought F.C. Clutch So I bought F.C.C. Clutch When I installed it and held the Lever, it was very light and I could con...Read More
THE LARGEST
SHOP IN JAPAN
EXCLUSIVE COUPONS,
SALE, DEALS
FAST, RELIABLE
SHIPPING