*Please use double-sided tape for installation.(Double-sided tape is not included) *Electro-tap (wiring clip) is included, so you can wire it with only one pair of pliers. *There is no box, manual or warranty card.It is a new product, but there are some small scratches that may have been caused by the manufacturing process, transportation, storage, etc. *It can be installed on the curved line, but if it is bent forcibly, there is a possibility of disconnection and partial lighting will be lost.In addition, there is a case that the product hardens by the temperature change etc.It will become softer if you warm it up with a hair dryer, but please be careful not to overheat it.
Ultra high brightness!Ultra thin SMD-LED tape with 3mm thickness!You can stick it on curved lines as well as straight lines! It can be installed on both cars and bikes by simply connecting to the "+" and "-". Adjustable to your desired length by cutting 3 pieces at a time!(SMD-LEDs and resistors are arranged, so please cut 3 pieces at a time to avoid cutting the resistors.) A dress-up item that offers endless possibilities depending on your ideas! Since it is waterproof, it can be installed in various places such as tire house, underbody of the vehicle, etc. even in rainy weather.
Points of Attention
* If there may be an instruction manual included, it will be written in Japanese.
Recently viewed products
Ratings & reviews for this product or related products
Purchase to attach StopLight to Kijima's Rear box attached to GIVI's Monokey base. The LED can be TapeCut in units of 1 Unit, so it was possible to adjust it to just the right length. Because ... Because the Instruction Manual is not on, it is difficult to understand by examining with Rides Corporation's HP, but the position of Cut was listed. Even though I cut this place I felt uneasy about Large durability but it went well. Brightness can be recognized even during the day so it is bright enough at night. Since Tape 's Tube is transparent, it has a rectangular White LEDTip, so I tried painting with Red Magic but it did not affect the brightness.View Detail
I bought it because I wanted to give a little LightUp to Motorcycle with Cowl. The price was pretty cheap, but the reason why Impression of other people was good is the reason why I chose this product.
We installed the installation place in the groove of the inner Duct so as to shine so that the light source can not be seen from the Side cowl heat emission Duct of Cowl car. It is a relatively short distance from the Exhaust pipe of the Exhaust System, so I was a bit worried, but now it glows without a problem.
I was worried because it was cheap, but I think that the brightness is enough. Quantity : Pair (for Left and Right) In, Quantity : By 2 pc, 4, the inside of Cowl is generally shimmer. I think that we can use with confidence by having Waterproof also. Coloring and Length also have various Patterns, so it's a recommended item.
When installing in Cowl, of course there is also desorption, so do not forget Coupleretc. Do not forget to buy it! You can arrange them all at Emon.View Detail
Although the Meter was before used as the LED ball, in order that only two balls might enter in a Meter at one side, it is almost changeless, and the difference was come out and troubled by brightness on either side.The place which was regarded as whether there is any anything else and was being looked for, and this product are discovered.Since the price was also cheap, it decided to purchase to a trial and to roll this LED Tape directly in a Meter..Result ...it is bright awfully and too dazzling -- it is -- ! (smile). it is -- although -- since brightness on either side also became the same and the whole Meter shone, a result satisfying in itself was brought.In a direction to make bright, I think that it is a Recommendation.View Detail
Compared with the car, it attached for the safety of a Motorcycle with bad visibility, and a night run.I am likely to become the quantity of light with splendid one, and am likely to get 2 Rear fenders to notice in existence of a self-vehicle even from a distance in the Cowl.View Detail
It has attached on the Handle cover.Since it often shines with it being unexpected although LED itself is small one by one, it is dramatically beautiful.I think that it can be dressed up at any cost according to a Sense since form and die length can be adjusted somewhat liking.Also when the installation itself is easy and it is stuck, it only sticks with double-stick tape.View Detail
* The BEST and MUST store to find Japanese parts. * Register now for amazing deals and other special offers! *Over 800,000 listed items. It's hard NOT to find your parts.
SIGN IN TO WEBIKE JAPAN
Please enter email at least 6 characters.
Please enter a valid email address.
Email is already in use.
Your account has been banned.
Email address and/or password is not match.
Authentication with facebook fail.Please try again.
Please select How did you get to know about Webike Japan?
OR
YOUR ACCOUNT HAS BEEN CREATED!
Congratulations! Your new account has been successfully created! You can now take advantage of member privileges to enhance your online
shopping experience with us. If you have ANY questions about the
operation of this online shop, please email Webike through CONTACT US.
A confirmation has been sent to the provided email address. If you
have not received it within the hour, please contact us.
Get on your grid by register your motorcycle! About our "Mybike" service
"Easier to Search Items" It helps you to search items to fit for your motorcycle!
"Get Much Valuable Information" It helps you to get special deals, newly listed items and closeouts about your motorcycle!
"Easy to Register" It requires only your motorcycle manufacturer, model name and model year!