[Size (harness length)] ・Input harness / approx. 1300mm ・Output harness / approx. 250mm [Specification] ・Waterproof design ・Power ON/OFF by main key interlocking ・Attach up to three accessories individually ・Bullet terminal (CA/CB103) 3 ports ・Trip current: 7.5A x 2 systems (recommended current: 4A*), 5A x 1 system (Recommended current: 2A*) *due to use of PTC thermistor ・High power design of 20A [Product Configuration] ・Main unit x 1 ・Double-sided tape x 1 ・Wiring connector x 1 ・Binding bands x 2 ・Cable ties (release type) x 2
*Keep the terminal connections away from water. *PTC thermistors manage the current flowing through them by heat and resistance values.When the current exceeds the specified current, the resistance value becomes high (high temperature) and it will shut down.If an electronic device is left connected in this state, the temperature will not drop and there is a possibility that the body will melt.If the connected equipment stops working, disconnect it as soon as possible. *Because the unit itself generates heat, it is not recommended to install the unit under the seat or in other places where heat is likely to accumulate. *Please do the wiring processing separately for the connection to each electric equipment. *There may be changes in product specifications due to the manufacturer's reasons.
Bulk power management. Easily extract multiple 12V power sources. Rainproof and compact accessory power supply. Compact power supply unit with three accessory (ACC) power sources. The power supply can be turned on and off by interlocking with the main key, and can be installed in any place with waterproof design. Up to three accessories can be attached individually. Dependable high power design. By taking the main power directly from the battery, it is possible to achieve high output while reducing the burden on the stock electrical equipment. Can be installed anywhere. It is waterproof and can be installed in the rainy place.
Points of Attention
* If there may be an instruction manual included, it will be written in Japanese.
Recently viewed products
Ratings & reviews for this product or related products
It is quite small than i expected and that makes easier to find the location for install power supply.I connected heated grip there and work quite well.Highly recommend product.View Detail
I purchased this for charging my phone and for navigation power. I chose this one because the power supply around the handlebar is messy, and I installed it under the Seat, even though the body is supposed to be waterproof. It works fine. I recommend it because it is inexpensive.View Detail
I installed it while servicing my ZOOMER. I had previously installed D-UNIT, a different version of this product, on my ZX-10R, but was attracted by the waterproof specification and compactness of this product, so I installed it on my ZOOMER as well. I installed it in the position shown in the picture, and the ACC power is supplied from BlinkerWiring. The work itself is not difficult, but if you do not have basic knowledge of electrical systems, it would be safer to ask a shop to do it for you. After installation, check the power with an energizing tester. We are planning to install Fog light etc. in the future.View Detail
After installing the driver's license camera, I will also install ETC in the future and may buy electric heating wire next season, so I installed it to facilitate wiring.
I was torn between other products in the Series, but I didn't need a constant power supply and I was worried about the shape of the product. Select this one, which is the simplest, smallest, waterproof, and lowest price.
Since it was after installing the driver's camera, I redid the wiring from the middle of the process and installed it and Refreshing it. If multiple power distribution is required, it is good because once it is attached, the rest is easy.View Detail
[How is it used? In order to add electrical components, we decided to obtain a power supply that is energized by the Ignition key linkage.
Was the one you received as per Image? Its very compact size allows for installation in small spaces.
Was the installation difficult? The wire is 1300mm long, which is long enough, although it is a little far from the battery location. There is a hole on the D-UNITBodyReverse side to put the tie band through.
How was your experience with it? It is very convenient because it is linked to the ON/OFF operation of the Ignition key.
[Included Parts:were they on? A complete set of parts required for vehicle installation is included in the package.
[Was there anything that disappointed you? Nothing.View Detail
* The BEST and MUST store to find Japanese parts. * Register now for amazing deals and other special offers! *Over 800,000 listed items. It's hard NOT to find your parts.
SIGN IN TO WEBIKE JAPAN
Please enter email at least 6 characters.
Please enter a valid email address.
Email is already in use.
Your account has been banned.
Email address and/or password is not match.
Authentication with facebook fail.Please try again.
Please select How did you get to know about Webike Japan?
OR
YOUR ACCOUNT HAS BEEN CREATED!
Congratulations! Your new account has been successfully created! You can now take advantage of member privileges to enhance your online
shopping experience with us. If you have ANY questions about the
operation of this online shop, please email Webike through CONTACT US.
A confirmation has been sent to the provided email address. If you
have not received it within the hour, please contact us.
Get on your grid by register your motorcycle! About our "Mybike" service
"Easier to Search Items" It helps you to search items to fit for your motorcycle!
"Get Much Valuable Information" It helps you to get special deals, newly listed items and closeouts about your motorcycle!
"Easy to Register" It requires only your motorcycle manufacturer, model name and model year!